![]() ![]()
While the below appears to be a text report file, you can actually overwrite the settings to change the SCADA baud rate and other settings. If you change this selection back to “DNP Map Standard….”, all your DNP settings in the I/O matrix will be lost! Note that the below example shows “” which indicates that the DNP map has been changed from the manufacturer’s standard. In the “Interfaces” object (below), the “Additional protocols at device” is used to set general SCADA parameters. ![]() Select File/Print, then select “Configuration – Short”, then “System Interface”.Right-hand click in the left-hand columns (Number, Display text, Long Text, Type) and select Properties to access the dialog to change the DNP index points and scaling, etc.Right-click and assign with “X” the desired items to be routed to the System Interface (S) – In the Source Colum for items to be controlled by SCADA, and the in Destination Colum for items to be output to SCADA.Ensure the filter is selected to allow you to see Commands, Indications, or Measured Values, etc as required.To set/change mapping, use the I/O Matrix Note that if creating a setting file from a blank template, make sure the selected MLFB for the target relay includes a DNP protocol card, otherwise the points on the Matrix will not be able to be assigned to the DNP interface. (“System Interface” is Siemens term for the SCADA interface). Mapping is achieved by routing items in the I/O matrix to/from the System Interface. The map is loaded/updated as part of the relay settings. This provides a general overview of the process of setting/modifying DNP 3.0 maps in Siemens SIPROTEC 4 series Protection Relays, using DIGSI 4.ĭNP 3.0 mapping information is part of the DIGSI “.dex” file information. Now DIGSI 5 V7.5 and DIGSI 5 V7.8 are also available on the SIEMENS websiteĭIGSI 5 Training contact us and reserve your seat. #PYROSIM DEVICE CLOCK MANUAL#SIPROTEC 5 Engineering Guide DIGSI 5 Manual SIPROTEC 5 Engineering Guide DIGSI 5 Manual SIPROTEC 5 Hardware Description Manual SIPROTEC 5 Hardware Description Manual SIPROTEC 5 Operation Manual SIPROTEC 5 Manual #PYROSIM DEVICE CLOCK SOFTWARE#Training on DIGSI 4 and DIGSI 5 Training, contact usĭIGSI 5 Software Description DIGSI 5 Software Description You will find a detailed overview of the features of the 3 variants in the Help topic entitled Features of the Different DIGSI 5 Variants. The advantages of flexible engineering and functional naming for IEC 61850. You analyze fault records with SIGRA and you use DIGSI 5 Premium is the high-end variant of DIGSI 5. #PYROSIM DEVICE CLOCK FULL#DIGSI 5 Standard offers full IEC 61850 support, including system configuration. With DIGSI 5 Standard, you simulate the topology of a system as a 1- 1-phase representation and you configure hardware and networks on a graphical basis. This variant includes, among others, a display editor which you can now also use to create your own symbols.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |